BOATSAFE 250W ENGINE HEATER COMPARTMENT HEATER 150

Home > Boating > Miscellaneous > Misc & Special Order >

BOATSAFE 250W ENGINE HEATER COMPARTMENT HEATER 150CU FEET JR-250W

List Price: $399.00
Our Price: $349.00
Add to cart for lower price

Manufacturer's Part Number JR-250W

Stock Status: In Stock

Availability: Usually Ships in 1 to 2 Business Days.
Product Code: CW25144

Qty:

Description

SPECIFICATIONS - MODEL JR - 250W

(For Engine Compartments of 150 cu. ft. or less) (Boats with single engine, up to 24', or most sailboats)

NOTE: This heater WILL NOT provide adequate

protection for a boat that is stored out of the water on a lift, or on a trailer.

UNIT DIMENSIONS:

51/2"H x 41/2"W x 141/2" L - 1" Mounting Bracket at each end of unit. Weight - Approximately 4 lbs.

UNIT ENCLOSURE:

16 Ga. aluminum. Designed for exceptional strength and long life. CAD Vents for proper air flow and maximum heat distribution. Fully Powder Coated for scratch and corrosion resistance.

HEATING ELEMENT:

250W, Cast Alloy, completely sealed, specially designed and engineered for this application. Cast Alloy provides excellent corrosion resistance. Vibration resistant. Will not spark. UL recognized.

THERMOSTAT CONTROL:

Hermetically sealed. Factory calibrated and pre-set to activate heater unit when ambient air temperature falls below 45 F (approximately), and continue operation until ambient reaches 55 F (approximately). FM approved.

FAN:

Heavy Duty, computer style induction fan. Rated at 21 CFM. UL recognized. CSA certified.

POWER CORD:

15' - Rated 13A, heavy duty service. Includes a molded 3 prong plug. UL and CSA recognized.

UNIT DRAW:

Approximately 2.2A at 120V.

BTU OUTPUT:

860 BTU

COST TO OPERATE:

2/Hr. (Based on Average Electricity Cost of 8/KWH)

TEST OPERATION OF UNIT:

To "test" the unit when ambient air temperature is above 45^oF you must simulate an ambient below 45F. To create the simulation: With the heater unit plugged into a 120V power source, locate the 1/2" dia. hole marked "Test" on the end cover of the unit. Using the 6 oz. can of Freeze Mist spray supplied with your heater, insert the "straw" into the nozzle and spray a 2-3 second burst of mist into the "Test" hole. This will "trick" the thermostat into turning the heater "ON". After a period of time (30 sec. - 3 min.), the ambient temperature of your test environment will resume control of the thermostat and turn your heater "OFF".